How to configure VLAN on cisco router using 802.1q encapsulation protocol

Cisco Show Vlan. Cisco IOS Command Hierarchy When selecting the file read operation, Operation 1 reads the file header, which contains the header verification word and the file version number Router# show vlans dot1q Total statistics for 802.1Q VLAN 1: 441 packets, 85825 bytes input 1028 packets, 69082 bytes output Total statistics for 802.1Q VLAN 101: 5173 packets, 510384 bytes input 3042 packets, 369567 bytes output Total statistics for 802.1Q VLAN 201: 1012 packets, 119254 bytes input 1018 packets, 120393 bytes output Total.

What is the command to show which vlan a user or a device is connecting to on switch? in other words, how to look at the running config of the port a PC is plugged into? please advise! If the VLAN is allowed on a vlan trunk, but the other side of the trunk doesn't have that vlan, or doesn't allow it, it won't show as ACTIVE

How to configure VLAN on cisco router using 802.1q encapsulation protocol

Cisco 2960-X Series Switch Command Reference, Cisco IOS Release 15.0(2)EX OL-30123-01 17 VLAN Commands show vlan What is the command to show which vlan a user or a device is connecting to on switch? in other words, how to look at the running config of the port a PC is plugged into? please advise! Router# show vlans dot1q Total statistics for 802.1Q VLAN 1: 441 packets, 85825 bytes input 1028 packets, 69082 bytes output Total statistics for 802.1Q VLAN 101: 5173 packets, 510384 bytes input 3042 packets, 369567 bytes output Total statistics for 802.1Q VLAN 201: 1012 packets, 119254 bytes input 1018 packets, 120393 bytes output Total.

Cisco Show Commands VLAN Verification and Troubleshooting Commands. The following sample output from the show vlans dot1q command displays some internal information about the QinQ subsystem and is used for troubleshooting purposes (typically by Cisco engineers): Router# show vlans dot1q internal Internal VLAN representation on FastEthernet0/0: VLAN Id: 1 (.1Q, Fa0/0) VLAN Id: 201 (.1Q-in-.1Q tree, 3 elements) When selecting the file read operation, Operation 1 reads the file header, which contains the header verification word and the file version number

cisco show interface vlan membership » NetworkUstad. I will like to know if there is a command I can run on Nexus switch to show the ip address range assigned to each vlan on the network? For example Staff_vlan 100 what are the valid ip address for this vlan? I would like a list of vlans and their address ranges The undebug sw-vlan ifs command is the same as the no debug sw-vlan ifs command.